While moving the hem up on a pair of pants, I encountered a challenge. These track pants have a side zipper at the bottom. I could (and probably should) move the entire zipper up the seam, or I can cut off the zipper at the new hem edge. I did not want to have to reset the entire zipper, so I chose to cut it off. However, that meant I was without a zipper bottom stop. I attempted to salvage the existing zipper stops, but the metal became weak and broke. I didn’t have a ready supply of replacement zipper stops, so I began to look for something else to use. I found these in my jewelry supply stash: crimp bead covers. These easily fit over the zipper teeth and I simply clamped them around and flat against the zipper teeth with my flat nosed pliers. In my opinion, I think it looks much cleaner than standard replacement zipper stops!